# 进入系统视图
<H3C> system-view
# 创建本地用户geisnetwork,并进入本地用户视图.
[H3C] local-user geisnetwork
# 设置本地用户的认证口令为明文方式,口令为 123456
[H3C-luser-geisnetwork] password 123456
# 设置VTY用户的服务类型为Telnet.
[H3C-luser-geisnetwork] service-type telnet level 3
# 进入VTY0用户界面视图.
[H3C] user-interface vty 0
# 设置通过VTY0口登录交换机的Telnet用户进行Scheme认证.
[H3C-ui-vty0] authentication-mode scheme
# 设置从VTY0用户界面登录后可以访问的命令级别为3级别
[H3C-ui-vty0] user privilege level 3
# 设置VTY0用户界面支持Telnet协议.
[H3C-ui-vty0] protocol inbound telnet
#指定vlan1为管理VLAN
[H3C] management-vlan 1
#创建交换机管理vlan1的vlan接口并进入vlan接口视图
[H3C] interface vlan-interface 1
#配置管理vlan1接口的IP地址为123.253.X.X
[H3C-Vlan-interface1] ip address 123.253.X.X 255.255.255.0
[H3C-Vlan-interface1] quit
#配置缺省路由
[H3C] ip route-static 0.0.0.0 0.0.0.0 123.253.132.65
端口限速:
# 进入对应端口
[H3C] interface Ethernet 1/0/X
# 对端口E1/0/X的出方向报文进行流量限制为10Mbps
[H3C] line-rate outbound 10240
# 对端口E1/0/X的入方向报文进行流量限制为10Mbps
[H3C] line-rate inbound 10240
附:
user-interface vty 4
authentication-mode scheme
local-user xf
password simple bbs
service-type ssh level 3
undo ip http shutdown
