1、配置交换机的设备名称、管理VLAN和ITELNET：

<huawei>
[huawei] system-view
[huawei] vlan 5
[huawei-vlan5] management-vlan
[huawei-vlan5]quit
[huawei]interface vlanif 5
[huawei-vlanif5] ip address 10.10.1.1.24
[huawei-vlanif5]quit
[huawei]telnet server enable   //打开telent接口
[huawei]user-interface vty 0 4
[huawei-ui-vty0-4]protocol inbound telnet
[huawei-ui-vty0-4]authentication-mode aaa
[huawei-ui-vty0-4]idle-timeout 15
[huawei-ui-vty0-4]quit
[huawei] aaa
[huawei-aaa]local-user admin password irreversible-cipher Helloworl@6789
[huawei-aaa]local-user admin service-type telnet
[huawei-aaa]quit
[huawei]quit
<huawei>save

2、配置交换机接口，配置的对象一般为接口隔离、速率、双工

<swithch1>system-view
[switch1]port-ioslate mode 12 //端口隔离
[switch1]interface gigabitethernet 1/0/1
[switch1-GigabitEthernet 1/0/1]port-isolate enable group 1
[switch1-GigabitEthernet 1/0/1]quit
[switch1]interface gigabitethernet 1/0/2
[switch-GigabitEthernet 1/0/2]port-isolate enable group 1
[switch-GigabitEthernet 1/0/2]quit

3、配置以太网接口GE0/0/1在自协商模式下速率为100Mb/s

<switch1>system-view
[switch1]interface gigabitethernet 0/0/1
[switch-GigabitEthernet 0/0/1]negotiation auto
[switch-GigabitEthernet 1/0/1]auto speed 100

4、配置以太网接口GE0/0/1在自协商模式下双工模式为全双工

<switch1>system-view
[switch1]interface gigabitEthernet 0/0/1
[switch-GigabitEthernet0/0/1]negotiation auto

5、查看MAC地址表，由MAC、VLAN和端口组成

<switch1>display mac-address

6、显示VLANIF接口的MAC地址

<switch1>display interface vlanif5

7、在MAC地址表中增加静态MAC地址表项，目的MAC地址为0001-0002-0003，vlan5报文

[switch1]mac-address static 0001-0002-0003 gigabitetherbet 0/0/5 vlan 5