交换机是交换数据，只能识别MAC地址，而交换机可以转发数据包，能够识别IP地址，所以能够转发数据包。而三层交换机的也有路由功能，所以也能转发数据包。今天这堂课就有三层交换机实现不同vlan间通信来加以验证。
器材：三层交换机一台，二层交换机一台。电脑三台，带水晶头双绞线若干。
过程:
1:连线，把PC1,PC2分别连到三层交换机的fa0/1,fa0/6.把PC3连到二层交换机fa0/1。再用一根线一端连到二层交换机的fa0/10，另一端连到三层交换机fa0/10.
2:对交换机进行配置：
二层交换机的配置
Switch>en
Switch#conf t
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)#int fa0/10
Switch(config-if)#sw mode acc
Switch(config-if)#sw mode trunk
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/10, changed state to down
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/10, changed state to up
Switch(config-if)#ex
Switch(config)#vlan 10
Switch(config-vlan)#ex
Switch(config)#int fa0/1
Switch(config-if)#sw acc vlan 10
Switch(config-if)#ex
Switch(config)#host 2chensw
三层交换机的配置
Switch>en
Switch#conf t
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)#host 3chensw
3chensw(config)#vlan 10
3chensw(config-vlan)#exi
3chensw(config)#vlan 20
3chensw(config-vlan)#ex
3chensw(config)#int fa0/1
3chensw(config-if)#sw acc vlan 10
3chensw(config-if)#ex
3chensw(config)#int fa0/2
3chensw(config-if)#sw acc vlan 20
3chensw(config-if)#ex
3chensw(config)#int fa0/10
3chensw(config-if)#sw mode trunk
Command rejected: An interface whose trunk encapsulation is "Auto" can not be configured to "trunk" mode.
3chensw(config-if)#sw mode acc
3chensw(config-if)#sw mode trunk
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/10, changed state to down
%LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/10, changed state to up
3chensw(config-if)#int vlan 10
%LINK-5-CHANGED: Interface Vlan10, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan10, changed state to up
3chensw(config-if)#ip add 10.10.10.254 255.255.255.0
3chensw(config-if)#no shut
3chensw(config-if)#ex
3chensw(config)#int vlan 20
%LINK-5-CHANGED: Interface Vlan20, changed state to up
%LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan20, changed state to up
3chensw(config-if)#ip add 20.20.20.254 255.255.255.0
3chensw(config-if)#no shut
3：PC1,PC2,PC3的IP分别设为：10.10.10.1，20.20.20.1，10.10.10.2.
4：测试：用PC1分别PING PC2,PC3.
PC>ping 10.10.10.2
Pinging 10.10.10.2 with 32 bytes of data:
Reply from 10.10.10.2: bytes=32 time=32ms TTL=128
Reply from 10.10.10.2: bytes=32 time=13ms TTL=128
Reply from 10.10.10.2: bytes=32 time=18ms TTL=128
Ping statistics for 10.10.10.2:
Packets: Sent = 3, Received = 3, Lost = 0 (0% loss),
Approximate round trip times in milli-seconds:
Minimum = 13ms, Maximum = 32ms, Average = 21ms
PC>ping 20.20.20.1
Pinging 20.20.20.1 with 32 bytes of data:
Request timed out.
Reply from 20.20.20.1: bytes=32 time=5ms TTL=127
Reply from 20.20.20.1: bytes=32 time=3ms TTL=127
Reply from 20.20.20.1: bytes=32 time=3ms TTL=127
验证完成，PC1,PC2间实现了 VLAN10和 VALN 20 之间的通信，以及通过设配串口fa0/10，实现在跨交换机之间通信。
