Question: 1
You have entered the following BGP configuration:
-Setvrouter trust-vr bgp 65530
-Setvrouter trust-vr bgp enable
-Setvrouter trust-vr protocol bgp neighbor 1.1.1.250 remote-as 65500
-Setvrouter trust-vr protocol bgp neighbor 1.2.3.250 remote-as 65280
BGP is not working. What two elements are missing from your configuration? (Choose two.)
A. You have not enabled the BGP peers.
B. You have not enabled EBGP multihop.
C. You have not placed the peers in a BGP peer group.
D. You have not enabled BGP on the interfaces connecting to the peers.
Answer: A,D
Question: 2
Which of the following protocols is required in order to deploy AutoConnect-×××s?
A. PKI
B. OSPF
C. NSRP
D. NHRP
Answer: D
Question: 3
What are three components that make up a redundant ××× configuration? (Choose three.)
A. master
B. targets
C. monitor
D. backups
E. ××× groups
Answer: B,C,E
Question: 4
Which ScreenOS CLI command(s) allow(s) for redistribution of type 1-3 LSAs?
A. set ospf export route external
B. set match route-type internal-ospf
C. set redistribute ospf lsa 1
set redistribute ospf lsa 2
set redistribute ospf lsa 3
D. set protocol ospf lsa 1 redistribute
set protocol ospf lsa 2 redistribute
set protocol ospf lsa 3 redistribute
Answer: B
Question: 5
What must be configured differently for a route-based ××× and a policy-based ×××?
A. proxy-id
B. proposals
C. remote gateway type
D. binding the tunnel interface
Answer: D
本文来源：ciscodk.com
