apt install squid -y vim /etc/squid/squid.conf http_port 3128 http_access allow all mkdir -p /etc/systemd/system/docker.ser
nano /etc/gdm3/greeter.dconf-defaults banner-message-enable=true banner-message-text='IP: ' nano /usr/local/bin/update-login-ip #!/bin/sh # 取默认路由所在接口
/etc/inittab 要密码 console::respawn:/sbin/getty -L console 0 vt100 不用输入密码 ::askfirst:-/bin/sh 例如： # Put a getty on the serial port#console::respawn:/sbi
mkpasswd -m "md5" "123456" $1$zkHqKM34$4o3L7AVagzaUURBNvTSyK0 or $1$9pcWhscT$cMXk8XA7skTO07wQZQuFR1
#include <stdio.h> #include <unistd.h> #include <fcntl.h> #include <termios.h> #include <sys/ioctl.h> void set_rts(int fd, int state) { int status; io
https://cf.trackerslist.com/best.txt
数字万用表，二极管档 红笔 GND 黑笔 GPIO 0.5xx 黑笔 VCC 3.3V 红笔 GPIO 0.5xx
jpnevulator安装： apt install jpnevulator 运行： jpnevulator --tty=/dev/ttyS4 --pty --pass --read --ascii --timing-print
// 将 NV12 转换为 BGR void nv12ToBgr(const unsigned char* yuvData, int width, int height, Mat& bgrImage) { // 计算每个平面的大小 int ySi
void crop_yuv420_sp(unsigned char *srcbuf, int src_width, int src_height, unsigned char *dstbuf, int x, int y, int w, int h) { int i; int dst_y_size =
apt install lightdm 然后选择lightdm reboot 重新选择 dpkg-reconfigure lightdm nano /usr/share/lightdm/lig
1.sudo nano /etc/pam.d/gdm-autologinsudo nano /etc/pam.d/gdm-password #auth required pam_succeed_if.so user != root quiet_success 2.sudo nano /root/.p
ssh-keygen -t rsa -b 4096 -C "your_email@example.com" ssh-copy-id -p 1234 root@ddns.1.2 Host ddns.1.2 HostName ddns.1.2 User root Po
gpedit.msc 计算机配置-管理模板-网络-Lanman工作站”， 启用不安全的来宾登录
NAT机器 ifconfig enp0s20f0u1i2 192.168.1.1 netmask 255.255.255.0 echo 1 > /proc/sys/net/ipv4/ip_forward iptables -t nat -A POSTROUTING -s 192.168.1.0/24
Copyright © 2005-2025 51CTO.COM 版权所有 京ICP证060544号
