2018-05-23 Linux学习

原创

wenlong2022 2018-05-22 23:28:04 ©著作权

文章标签 Linux 学习 文章分类 运维

©著作权归作者所有：来自51CTO博客作者wenlong2022的原创作品，请联系作者获取转载授权，否则将追究法律责任

18.11 LVS DR模式搭建（推荐）

DR模式搭建 – 准备工作

三台机器分发器，也叫调度器（简写为dir） 133.130 rs1 133.132 rs2 133.133 vip 133.200

DR模式搭建

dir上编写脚本 vim /usr/local/sbin/lvs_dr.sh //内容如下 #! /bin/bash echo 1 > /proc/sys/net/ipv4/ip_forward ipv=/usr/sbin/ipvsadm vip=192.168.133.200 rs1=192.168.133.132 rs2=192.168.133.133 #注意这里的网卡名字 ifconfig ens33:2 $vip broadcast $vip netmask 255.255.255.255 up route add -host $vip dev ens33:2 $ipv -C $ipv -A -t $vip:80 -s wrr $ipv -a -t $vip:80 -r $rs1:80 -g -w 1 $ipv -a -t $vip:80 -r $rs2:80 -g -w 1

两台rs上也编写脚本 vim /usr/local/sbin/lvs_rs.sh//内容如下 #/bin/bash vip=192.168.133.200 #把vip绑定在lo上，是为了实现rs直接把结果返回给客户端 ifconfig lo:0 $vip broadcast $vip netmask 255.255.255.255 up route add -host $vip lo:0 #以下操作为更改arp内核参数，目的是为了让rs顺利发送mac地址给客户端 #参考文档www.cnblogs.com/lgfeng/archive/2012/10/16/2726308.html echo "1" >/proc/sys/net/ipv4/conf/lo/arp_ignore echo "2" >/proc/sys/net/ipv4/conf/lo/arp_announce echo "1" >/proc/sys/net/ipv4/conf/all/arp_ignore echo "2" >/proc/sys/net/ipv4/conf/all/arp_announce 分别在dir上和两个rs上执行这些脚本测试

操作过程

rs网关改回可正常连接外网

[root@linux-02 ~]# vim /etc/sysconfig/network-scripts/ifcfg-ens33
IPADDR=192.168.106.165
NETMASK=255.255.255.0
GATEWAY=192.168.106.2
DNS1=119.29.29.29
[root@linux-02 ~]# systemctl restart network

[root@linux-03 ~]# vim /etc/sysconfig/network-scripts/ifcfg-ens33
IPADDR=192.168.106.166
NETMASK=255.255.255.0
GATEWAY=192.168.106.2
DNS1=119.29.29.29
[root@linux-03 ~]# systemctl restart network

[root@linux-01 ~]# vim /usr/local/sbin/lvs_dr.sh #! /bin/bash echo 1 > /proc/sys/net/ipv4/ip_forward ipv=/usr/sbin/ipvsadm vip=192.168.106.200 rs1=192.168.106.165 rs2=192.168.106.166 #注意这里的网卡名字 ifdown ens33 ifup ens33 ifconfig ens33:2 $vip broadcast $vip netmask 255.255.255.255 up route add -host $vip dev ens33:2 $ipv -C $ipv -A -t $vip:80 -s wrr $ipv -a -t $vip:80 -r $rs1:80 -g -w 1 $ipv -a -t $vip:80 -r $rs2:80 -g -w 1

[root@linux-01 ~]# sh /usr/local/sbin/lvs_dr.sh
成功断开设备 'ens33'。
连接已成功激活（D-Bus 活动路径：/org/freedesktop/NetworkManager/ActiveConnection/3

rs两台配置同样的脚本

[root@linux-02 ~]# vim /usr/local/sbin/lvs_rs.sh #/bin/bash vip=192.168.106.200 #把vip绑定在lo上，是为了实现rs直接把结果返回给客户端 ifdown lo ifup lo ifconfig lo:0 $vip broadcast $vip netmask 255.255.255.255 up route add -host $vip lo:0 #以下操作为更改arp内核参数，目的是为了让rs顺利发送mac地址给客户端 #参考文档www.cnblogs.com/lgfeng/archive/2012/10/16/2726308.html echo "1" >/proc/sys/net/ipv4/conf/lo/arp_ignore echo "2" >/proc/sys/net/ipv4/conf/lo/arp_announce echo "1" >/proc/sys/net/ipv4/conf/all/arp_ignore echo "2" >/proc/sys/net/ipv4/conf/all/arp_announce

[root@linux-02 ~]# sh /usr/local/sbin/lvs_rs.sh


[root@linux-03 ~]# vim /usr/local/sbin/lvs_rs.sh
[root@linux-03 ~]# sh /usr/local/sbin/lvs_rs.sh


所有机器上都可以看到绑定的vip 192.168.106.200

[root@linux-01 ~]# ip add

测试

Mikes-MacBook-Pro:~ mike$ curl http://192.168.106.200/
aminglinux03
Mikes-MacBook-Pro:~ mike$ curl http://192.168.106.200/
aminglinux02
Mikes-MacBook-Pro:~ mike$ curl http://192.168.106.200/
aminglinux03
Mikes-MacBook-Pro:~ mike$ curl http://192.168.106.200/
aminglinux02


[root@linux-01 ~]# ipvsadm -ln
IP Virtual Server version 1.2.1 (size=4096)
Prot LocalAddress:Port Scheduler Flags
  -> RemoteAddress:Port           Forward Weight ActiveConn InActConn
TCP  192.168.106.200:80 wrr
  -> 192.168.106.165:80           Route   1      0          2         
  -> 192.168.106.166:80           Route   1      0          2

18.12 keepalived lvs

完整架构需要两台服务器（角色为dir）分别安装keepalived软件，目的是实现高可用，但keepalived本身也有负载均衡的功能，所以本次实验可以只安装一台keepalived
keepalived内置了ipvsadm的功能，所以不需要再安装ipvsadm包，也不用编写和执行那个lvs_dir的脚本
三台机器分别为：
dir（安装keepalived）133.130
rs1 133.132
rs2 133.133
vip 133.200

dir上编写脚本 vim /usr/local/sbin/lvs_dr.sh //内容如下 #! /bin/bash echo 1 > /proc/sys/net/ipv4/ip_forward 以下四行不确定要不要 ***** ipv=/usr/sbin/ipvsadm vip=192.168.133.200 rs1=192.168.133.132 rs2=192.168.133.133

编辑keepalived配置文件 vim /etc/keepalived/keepalived.conf//内容请到https://coding.net/u/aminglinux/p/aminglinux-book/git/blob/master/D21Z/lvs_keepalived.conf 获取
需要更改里面的ip信息
执行ipvsadm -C  把之前的ipvsadm规则清空掉
systemctl restart network 可以把之前的vip清空掉
两台rs上，依然要执行/usr/local/sbin/lvs_rs.sh脚本
keepalived有一个比较好的功能，可以在一台rs宕机时，不再把请求转发过去
测试

操作过程

[root@linux-01 ~]# vim /etc/keepalived/keepalived.conf vrrp_instance VI_1 { #备用服务器上为 BACKUP state MASTER #绑定vip的网卡为ens33，你的网卡和阿铭的可能不一样，这里需要你改一下 interface ens33 virtual_router_id 51 #备用服务器上为90 priority 100 advert_int 1 authentication { auth_type PASS auth_pass aminglinux } virtual_ipaddress { 192.168.106.200 } } virtual_server 192.168.106.200 80 { #(每隔10秒查询realserver状态) delay_loop 10 #(lvs 算法) lb_algo wlc #(DR模式) lb_kind DR #(同一IP的连接60秒内被分配到同一台realserver) persistence_timeout 60 #(用TCP协议检查realserver状态) protocol TCP real_server 192.168.106.165 80 { #(权重) weight 100 TCP_CHECK { #(10秒无响应超时) connect_timeout 10 nb_get_retry 3 delay_before_retry 3 connect_port 80 } } real_server 192.168.106.166 80 { weight 100 TCP_CHECK { connect_timeout 10 nb_get_retry 3 delay_before_retry 3 connect_port 80 } } }

[root@linux-01 ~]# systemctl stop keepalived.service 
[root@linux-01 ~]# ipvsadm -ln
IP Virtual Server version 1.2.1 (size=4096)
Prot LocalAddress:Port Scheduler Flags
  -> RemoteAddress:Port           Forward Weight ActiveConn InActConn


[root@linux-01 ~]# systemctl start keepalived
[root@linux-01 ~]# ipvsadm -ln
IP Virtual Server version 1.2.1 (size=4096)
Prot LocalAddress:Port Scheduler Flags
  -> RemoteAddress:Port           Forward Weight ActiveConn InActConn
TCP  192.168.106.200:80 wlc persistent 60
  -> 192.168.106.165:80           Route   100    0          0         
  -> 192.168.106.166:80           Route   100    0          0

测试

[root@linux-03 ~]# systemctl stop nginx.service

[root@linux-01 ~]# ipvsadm -ln
IP Virtual Server version 1.2.1 (size=4096)
Prot LocalAddress:Port Scheduler Flags
  -> RemoteAddress:Port           Forward Weight ActiveConn InActConn
TCP  192.168.106.200:80 wlc persistent 60
  -> 192.168.106.165:80           Route   100    0          0 


[root@linux-03 ~]# systemctl start nginx.service

[root@linux-01 ~]# ipvsadm -ln
IP Virtual Server version 1.2.1 (size=4096)
Prot LocalAddress:Port Scheduler Flags
  -> RemoteAddress:Port           Forward Weight ActiveConn InActConn
TCP  192.168.106.200:80 wlc persistent 60
  -> 192.168.106.165:80           Route   100    0          0         
  -> 192.168.106.166:80           Route   100    0          0

访问测试

Mikes-MacBook-Pro:~ mike$ curl http://192.168.106.200/
aminglinux03

[root@linux-01 ~]# ipvsadm -ln
IP Virtual Server version 1.2.1 (size=4096)
Prot LocalAddress:Port Scheduler Flags
  -> RemoteAddress:Port           Forward Weight ActiveConn InActConn
TCP  192.168.106.200:80 wlc persistent 60
  -> 192.168.106.165:80           Route   100    0          0         
  -> 192.168.106.166:80           Route   100    0          9