一、基本实验配置 R1 参考配置 配置接口地址 interface Loopback0 ip address 172.16.1.1 255.255.255.0 interface Loopback1 ip address 172.16.2.1 255.255.255.0
interface Loopback2 ip address 10.1.1.1 255.255.255.0
interface FastEthernet0/0 ip address 200.1.1.1 255.255.255.0 no shutdown
配置RIP路由： router rip version 2 timers basic 5 10 10 15 修改计时器 network 10.0.0.0 network 172.16.0.0 network 200.1.1.0 no auto-summary
R2参考配置 接口地址配置 interface FastEthernet0/0 ip address 200.1.1.2 255.255.255.0 no shutdown
interface FastEthernet1/0 ip address 200.1.2.1 255.255.255.0 no shutdown
RIP路由配置
router rip
version 2
timers basic 5 10 10 15 修改计时器
network 200.1.1.0
network 200.1.2.0
no auto-summary
R3 参考配置 interface Loopback0 ip address 192.168.1.1 255.255.255.0
interface FastEthernet0/0 ip address 200.1.2.2 255.255.255.0 no shutdown
router rip version 2 timers basic 5 10 10 15 network 192.168.1.0 network 200.1.2.0 no auto-summary
配置完成后在R2上查看路由 R 172.16.1.0/24 is possibly down, routing via 200.1.1.1, FastEthernet0/0 R 172.16.2.0/24 is possibly down, routing via 200.1.1.1, FastEthernet0/0 10.0.0.0/24 is subnetted, 1 subnets R 10.1.1.0 [120/1] via 200.1.1.1, 00:00:01, FastEthernet0/0 R 192.168.1.0/24 [120/1] via 200.1.2.2, 00:00:01, FastEthernet1/0
在R2过滤掉172.16.0.0 的路由
第一步创建列表
access-list 10 deny 172.16.0.0 0.0.255.255
access-list 10 permit any
第二步确定方向和接口，并应用分发列表
R2(config)#router rip
R2(config-router)#distribute-list 10 in FastEthernet0/0
在f0/0口的in方向应用分发列表调用10号访问控制列表
查看路由**，172.16.0.0的路由已经消失，但10.1.1.0的路由依然可以看到**，说明实验成功 C 200.1.1.0/24 is directly connected, FastEthernet0/0 C 200.1.2.0/24 is directly connected, FastEthernet1/0 10.0.0.0/24 is subnetted, 1 subnets R 10.1.1.0 [120/1] via 200.1.1.1, 00:00:00, FastEthernet0/0 R 192.168.1.0/24 [120/1] via 200.1.2.2, 00:00:01, FastEthernet1/0
