U-boot下Nand Flash的相关命令
"nand - NAND sub-system\n",
"info - show available NAND devices\n"
"nand device [dev] - show or set current device\n"
"nand read[.jffs2] - addr off|partition size\n"
"nand write[.jffs2] - addr off|partiton size - read/write `size' bytes starting\n"
" at offset `off' to/from memory address `addr'\n"
"nand erase [clean] [off size] - erase `size' bytes from\n"
" offset `off' (entire device if not specified)\n"
"nand bad - show bad blocks\n"
"nand dump[.oob] off - dump page\n"
"nand scrub - really clean NAND erasing bad blocks (UNSAFE)\n"
"nand markbad off - mark bad block at offset (UNSAFE)\n"
"nand biterr off - make a bit error at offset (UNSAFE)\n"
"nand lock [tight] [status] - bring nand to lock state or display locked pages\n"
"nand unlock [offset] [size] - unlock section\n";
U-boot下Nand Flash的相关命令
原创protheschildren 博主文章分类:嵌入式 ©著作权
文章分类
©著作权归作者所有:来自51CTO博客作者protheschildren的原创作品,请联系作者获取转载授权,否则将追究法律责任
![](https://ucenter.51cto.com/images/noavatar_middle.gif)
提问和评论都可以,用心的回复会被更多人看到
评论
发布评论
相关文章
-
从Nand Flash启动U-BOOT的基本原理
前4K的问题 如果S3C2410被配置成从Nand Flash启动(配置由硬件工程师在电路板设置),
闪存 3c 初始化 嵌入式系统 数据 -
TQ2440移植u-boot2016.11全过程记录-【7】NAND FLASH方式启动U-BOOT
TQ2440移植u-boot2016.11-NAND FLASH方式启动U-BOOTS3C2440 U-BOOT启动方式说明R上运行...
TQ2440 u-boot移植 TQ2440移植NAND驱动 #define 初始化 -
【U-BOOT步骤】u-boot 移植步骤详解
U-BOOT 编写流程Bootloader的两部分:1、NANFLASH 前4KB 一开机就会被复制到RAM中,然后跳到R...
串口 linux u-boot移植 初始化 寄存器