架构图如下(随便画的,有点丑,将就看老早)

p_w_picpath

下面以CISCO WLC2106为例,简单介绍配置方法。下面粗体为需要配置的地方或注释。

Welcome to the Cisco Wizard Configuration Tool

Use the '-' character to backup  //这里需要输入ESC清空配制恢复出厂值,只要输入reconfig就好了

Would you like to terminate autoinstall? [yes]: yes

System Name [Cisco_a8:70:00] (31 characters max): cisco-2106-test

Enter Administrative User Name (24 characters max): admin

Enter Administrative Password (24 characters max): *****

Re-enter Administrative Password : *****

Management Interface IP Address: 192.168.1.1 //管理接口地址

Management Interface Netmask: 255.255.255.0

Management Interface Default Router: 192.168.1.254 //管理接口的默認路由

Management Interface VLAN Identifier (0 = untagged): 0 //缺省配置

Management Interface Port Num [1 to 8]: 1 //啟用port 1

Management Interface DHCP Server IP Address: 192.168.1.1 //DHCP server 地址

AP Manager Interface IP Address: 192.168.1.10 //AP的管理接口地址

AP-Manager is on Management subnet, using same values

AP Manager Interface DHCP Server (192.168.1.1): //缺省直接回車

Virtual Gateway IP Address: 1.1.1.1 //虛擬網關地址,當WEB認證時用到

Mobility/RF Group Name: 2106-test

Enable Symmetric Mobility Tunneling [yes][NO]: no

Network Name (SSID): test

Allow Static IP Addresses [YES][no]: yes

Configure a RADIUS Server now? [YES][no]: no //不配置認證

Warning! The default WLAN security policy requires a RADIUS server.

Please see documentation for more details.

Enter Country Code list (enter 'help' for a list of countries) [US]: us //國家區域碼

Enable 802.11b Network [YES][no]: yes

Enable 802.11a Network [YES][no]: yes

Enable 802.11g Network [YES][no]: yes

Enable Auto-RF [YES][no]: yes

Configure a NTP server now? [YES][no]: no

Configure the system time now? [YES][no]: no

Warning! No AP will come up unless the time is set.

Please see documentation for more details.

Configuration correct? If yes, system will save it and reset. [yes][NO]: yes

Configuration saved!

Resetting system with new configuration...

 

重启WLC 连接网络,GUI模式配制具体

GUI配制需要配制的有:port;interface;WLAN;RF group等

 

具体配置时,注意LAP的型号如:AIR-LAP1131AG-C-K9

其中C代表CISCO出中国的,那么国家区域码设置要有china(可以设置多个),不然接入LAP可能认不到。