今早发现ZS的***断了,要重设下路由,结果按后面的reset键时,试了几次却都不成功。后来发现要在接电前按住才有效,特地log之:
 
Reset to factory Default:

Reset to factory settings. Note this will erase all settings, including last firmware installed, upgrade keys and any type of configuration. Check Point recommends exporting settings before a reset to factory settings. You can reset factory settings in the following ways:

• Press and hold the reset button on the back of the appliance for 10 seconds. The PWR/SEC LED will blink red once pressed. Release the button once it stops blinking.

• You can do another type of factory-setting reset by following these steps:
Unplug the power cord.
Hold the reset button on the back of the appliance.
Plug in the power cord while holding the button, until the PWR/SEC LED blinks red steadily.
Press the reset button for 3 seconds.
Press the reset button again for 10 seconds until the PWR/SEC LED blinks red.
Reconfigure the appliance.